Honda Prelude Forum
Go Back   Honda Prelude Forum > Tech-Talk > 5th Gen Honda Prelude

Thread Title
Advice on replacing shift linkage for 5g

LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 03-16-2009, 02:20 PM
I'm New
Join Date: Feb 2009
Posts: 4
iTrader: (0)
b18c5__owns is on a distinguished road
Advice on replacing shift linkage for 5g

I broke the cable while doing my swap so in need of replacing the lines.
I've tried searching for any write up's or questions on replacing the lines and was not able to come up with anything. So I've been just trying to follow from any 5spd swap guides.

So, looking for any tips on what to expect or what I can do to make this job as easy as possible.

Reply With Quote
  #2 (permalink)  
Old 03-19-2009, 02:01 AM
distant's Avatar
Bronze Member
Join Date: Feb 2008
Location: idaho
Posts: 155
iTrader: (0)
distant will become famous soon enoughdistant will become famous soon enough
Re: Advice on replacing shift linkage for 5g

when i did my swap i had a slight issue with the linkage cables..

here is a pic.. the bottom circle shows a clamp that goes around both cables that you should be able to take off fairly easy.

I cut off the plate that has the two bolt holes in it. I couldn't make the holes line up to anything.. besides the fact that it was a bitch to move the lines over the cross beam and under the fire wall.. where the arrow is in the pic.

so after cutting the plate off I was left with just the clamp that held the two lines together..

Is your engine in your car our out?? mine was out so I just fed the lines over the cross beam and through the hole in the floor bard to the shift assembly.. hooked up the two lines but didn't put the U clip in.. then when i droped in my engine hooked up the two cables to the tranny and then added the U clips.

Does this help??
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Need Advice: Replacing Valve cover gasket chengvtec 5th Gen Honda Prelude 19 02-01-2009 12:54 PM
Clutch Linkage Adjustment OEM~KaOs General Tech Talk 5 10-28-2007 06:33 PM

All times are GMT -4. The time now is 06:24 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
LinkBacks Enabled by vBSEO 3.6.0 PL2 © 2011, Crawlability, Inc.

Copyright © 2006-2009 All Rights Reserved.