Ok my problem is that i am throwing CEL codes 3 and 22. i started throwing these as soon as i disconnected my VAFC2, just to let you know i have unwired the VAFC2. I have messed with both of these and did the cel reset many times but they keep popping up as if they are not plugged in.

i have a h22a swap into an SE with a p13 ecu ill double check on that.

CEL 3 MAP sensor
What i have tried: i have looked at the manual and tested the wires everything checks out except the wht wire. So i might need to replace that but before i do would the position of the map sensor have anything to do with me throwing this code, because the tab is broke where you screw it in and it is just dangling. I just didnt know if the position of it really mattered or not.u

CEL 22 VTEC pressure switch
i have checked the switches continuity and it has it. I have checked the volts between the wire and i am getting 13v. so not problem there. i have also tried another pressure switch and i am getting the same thing.

Like i said earlier i have messed with both of these and did the cel reset many times but they keep popping up as if they are not plugged in. Any help would be greatly appreciated.

Anybody????