Honda Prelude Forum
 
Go Back   Honda Prelude Forum > Tech-Talk > 4th Gen Honda Prelude

Thread Title
H22A wont start but with a twist

 
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 06-01-2010, 11:03 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
H22A wont start but with a twist

yes im aware thats theres millions of threads on web sites around the world but i can find a solution to my problem.


ok i completed a engine swap H22a to H22a. All i changed was the long block.
both engines were goin i drove them both 2mins b4 i took the engines out.
everything that is on the new engine i.e intake exhust manifold etc is off the old eengine.
the old engine had run a main bearing.

Engine cranks over.
engine has spark.
if i spray gas or anything in throttle body it fires but then dies.
it wiil not fire on its own.
ive tryed tow starting it and that hasnt worked.
ecu is P13 and been chiped with a spoon chip and havnt had any problems with it.
any ideas be really good
Reply With Quote
  #2 (permalink)  
Old 06-01-2010, 11:05 AM
twokexlv6coupe's Avatar
little green ghouls, buddy!!
Photobucket
 
Join Date: Apr 2006
Location: kitten mittens
Posts: 17,844
iTrader: (9)
twokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond repute
Send a message via AIM to twokexlv6coupe
Re: H22A wont start but with a twist

sounds like your not getting fuel. did you check for fuel @ the fuel rail?
__________________

1995 Honda Prelude SE Turbo; 250whp, 275wtq @ 10psi Soldddd!!!

2000 Acura TL; DD
2005 Stage2.5+ Subaru WRB STi : RzKar!
Ivey Tuned - Advan - Cobb - Rallispec - CP - Perrin - ACT - KillerB - Carillo - TurboXS - Defi - Innovate - Walbro - DeatschWerks - Feal - H&R - Alpine - Infiniti - Curt

2001 Kawasaki STX1100 D.I. - Sold!
2007 Sea-Doo RXT 215; ET 127 +3 S/C impeller, DIY 3" intake, DIY resonator delete/free flow exhaust, DIY oil catch can, Rule 500gph bilge pump


Quote:
Originally Posted by Brash View Post
But you need that scoop on the hood. Is it true that they're big enough to fit your lunch box and all your camera gear in it?
Reply With Quote
  #3 (permalink)  
Old 06-01-2010, 11:09 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

yip i used that to pour gas in to a bottle to pour it in the throttle body to get it to fire
Reply With Quote
  #4 (permalink)  
Old 06-01-2010, 11:13 AM
seed_man's Avatar
Not So New
 
Join Date: Apr 2010
Location: So Cal
Posts: 45
iTrader: (0)
seed_man is on a distinguished road
Re: H22A wont start but with a twist

Quote:
Originally Posted by twokexlv6coupe View Post
sounds like your not getting fuel. did you check for fuel @ the fuel rail?


X2!!! Can you hear the fule pump when you turn the key?
Reply With Quote
  #5 (permalink)  
Old 06-01-2010, 11:15 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

yes i can i disconnected the fuel line from fuel rail and filled a bottle up with gas then poured the gas into the throttle boby and it fired and revrd then died. So the fuel is getting from the tank via fuel pump to the fuel rail.but i dont think the fuel is getting into the cly is there a easy way to check the injectors i have a spare set if i need them

Last edited by SIRH22A; 06-01-2010 at 11:25 AM.
Reply With Quote
  #6 (permalink)  
Old 06-01-2010, 11:44 AM
BB4_Kuwait's Avatar
Junior Member
 
Join Date: Nov 2009
Location: Jahra
Posts: 97
iTrader: (0)
BB4_Kuwait is on a distinguished road
Re: H22A wont start but with a twist

change the injectors if you have a set anyways you will change them sooner or later.
and reset the ECU also after the installation, it is easy to change the oem injectors.
Reply With Quote
  #7 (permalink)  
Old 06-01-2010, 02:45 PM
JohnL114's Avatar
Silver Member
 
Join Date: Apr 2009
Location: Queens
Posts: 475
iTrader: (1)
JohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond reputeJohnL114 has a reputation beyond repute
Re: H22A wont start but with a twist

okay i am going to agree with some of the guys ,question did you checked all the grounds ?especially the one at the thermostat housing ..... also i wouldn't be surprise if the distributor is you culprit , they tend to go bad when doing swaps , try trouble shooting from the distributor harness make sure your getting the correct voltage and its has good continuity with grounds . a continuity meter is key and also a manual for the specs on the voltage hope this helps .Okay . keep update.
Reply With Quote
  #8 (permalink)  
Old 06-02-2010, 02:13 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

replaced all injectors there is no fuel getting into the clynders there is spark and when i pour gas into the throttle body it starts if i get pouring it it it will keep running and i can rev it but when i stop pouring gas in it dies. what would be the reasons why there no power getting to the injectors thanks
Reply With Quote
  #9 (permalink)  
Old 06-02-2010, 03:19 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

ecu isnt telling me any codes either how do i reset the ecu in my bb4?? its a p13 that has a spoon chip
Reply With Quote
  #10 (permalink)  
Old 06-02-2010, 10:42 AM
twokexlv6coupe's Avatar
little green ghouls, buddy!!
Photobucket
 
Join Date: Apr 2006
Location: kitten mittens
Posts: 17,844
iTrader: (9)
twokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond reputetwokexlv6coupe has a reputation beyond repute
Send a message via AIM to twokexlv6coupe
Re: H22A wont start but with a twist

here's a very dumb question, but ya never know....



is the resistor box plugged in??
__________________

1995 Honda Prelude SE Turbo; 250whp, 275wtq @ 10psi Soldddd!!!

2000 Acura TL; DD
2005 Stage2.5+ Subaru WRB STi : RzKar!
Ivey Tuned - Advan - Cobb - Rallispec - CP - Perrin - ACT - KillerB - Carillo - TurboXS - Defi - Innovate - Walbro - DeatschWerks - Feal - H&R - Alpine - Infiniti - Curt

2001 Kawasaki STX1100 D.I. - Sold!
2007 Sea-Doo RXT 215; ET 127 +3 S/C impeller, DIY 3" intake, DIY resonator delete/free flow exhaust, DIY oil catch can, Rule 500gph bilge pump


Quote:
Originally Posted by Brash View Post
But you need that scoop on the hood. Is it true that they're big enough to fit your lunch box and all your camera gear in it?
Reply With Quote
  #11 (permalink)  
Old 06-02-2010, 06:20 PM
90Lude2.0s's Avatar
Bronze Member
 
Join Date: Jan 2008
Posts: 212
iTrader: (0)
90Lude2.0s is on a distinguished road
Re: H22A wont start but with a twist

Are your injectors hooked up to the resistor box? Test if they are getting voltage to them
Reply With Quote
  #12 (permalink)  
Old 06-04-2010, 02:31 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

heres a even ddumber question Where is the resitor box???
Reply With Quote
  #13 (permalink)  
Old 06-04-2010, 04:48 AM
I'm New
 
Join Date: Jun 2010
Posts: 12
iTrader: (0)
SIRH22A is on a distinguished road
Re: H22A wont start but with a twist

omg i cnt belive how easy it was to get goin . Rite i found resitor box un pluged the plug sprayed it with crc spray pluged it back in and BINGO it goes thanks to everyone thats tryed to help again thanks heaps
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
h22a swap wont start 98prelude44 General Tech Talk 14 04-15-2013 06:57 PM
H22 in 93 SR wont start!! Troy93SRH22 General Tech Talk 11 05-18-2010 11:03 AM
Ran out of gas, car wont start dannelson 4th Gen Honda Prelude 22 04-20-2010 02:43 PM
h23 to h22 swap car wont start start hprelude559 4th Gen Honda Prelude 3 04-09-2010 06:54 PM
Wont Start NickRP1994si 4th Gen Honda Prelude 3 08-22-2009 04:40 PM


All times are GMT -4. The time now is 03:21 AM.



Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
LinkBacks Enabled by vBSEO 3.6.0 PL2 © 2011, Crawlability, Inc.
vB.Sponsors


Copyright © 2006-2009 PreludeZone.com All Rights Reserved.